Lennox G60UHV - Specifications

Page 3
SPECIFICATIONS
Gas
Heating
Performance
ModelNo. G60UHV−60C−110 G60UHV−60D−135
Low NOx Model No. G60UHV−60C−110X − − −
Input− Btuh (kW) low fire 75,000 (22.0) 90,000 (26.4)
Output− Btuh (kW) low fire 60,000 (17.6) 72,000 (21.1)
Input− Btuh (kW) high fire 110,000 (32.2) 132,000 (38.7)
Output− Btuh (kW) high fire 90,000 (26.4) 108,000 (31.6)
AFUE 80.0% 80.0%
California Seasonal Efficiency 77.2% 77.5%
Highstatic(CSA)− in.w.g. (Pa) .80 (200) .80 (200)
Flue connection − in. (mm) round 4 (102) 4 (102)
GaspipesizeIPS− in. (mm) 1/2 (12.7) 1/2 (12.7)
Temperature rise range − F (C) low fire 25 − 55 (14 − 31) 25 − 55 (14 − 31)
Temperature rise range − F (C) high fire 35 − 65 (19 − 36) 45 − 75 (25 − 42)
Indoor
Blower
Wheelnominaldiameter xwidth −in. (mm) 11−1/2 x 10 (292 x 254) 11−1/2 x 10 (292 x 254)
Motoroutput − hp (W) 1 (746) 1 (746)
Tons(kW) ofadd-oncooling 4 − 5 (14.1 − 17.6) 4 − 5 (14.1 − 17.6)
Shippingweight − 1 package 184 (83) 198 (90)
Matching Coils
Up−flow cased
C33−36C−2F, C33−48C−2F,
C33−50/60C−2F,
C33−60D−2F, C33−62D−2F
Horizontal
CH33−36C−2F, CH33−48C−2F,
CH33−50/60C−2F
CH33−60D−2F, CH33−62D−2F
Electricalcharacteristics 120 volts − 60 hertz − 1 phase (less than 12 amps)
OPTIONAL ACCESSORIES − MUST BE ORDERED EXTRA
 Air Filter and Rack Kit
Number and size of filters
Horizontal (end)
87L97
(1) 20 x 25 x 1 in. (508 x 635 x 25
mm)
87L98
(1) 25 x 25 x 1 in. (635 x 635 x 25
mm)
Side Return Single 44J22 or Ten Pack (66K63) − (1) 16 x 25 x 1 (406 x 635 x 25)
EZ Filter Base
Catalog Number − Shipping Weight 73P57 − 8 lbs. (4 kg) 73P58 − 10 lbs. (5 kg)
Dimensions − H x W x D
4 x 21−5/8 x 28−5/8 in.
(102 x 549 x 727 mm)
4 x 24−5/8 x 28−5/8 in.
(102 x 625 x 727 mm)
Number and size of field provided filter (1) 20 x 25 x 1 in. (508 x 635 x25 mm)
(1) 24 x 24 x 1 in. (610 x 610 x 25
mm)
CCB1 Efficiency Plust Humidity Control System 35H00 35H00
High Altitude Pressure Switch Kit See Page 7
Horizontal Support Frame Kit − Shipping Weight 56J18 − 18 lbs. (8 kg) 56J18 − 18 lbs. (8 kg)
LPG/Propane Kit See Page 7
RAB Return Air Base RAB60C (12M71) RAB60D (12M72)
Vent Adaptor − 6 in. 152 (mm) connection size 18M79 − 2 lbs. (1 kg) 18M79 − 2 lbs. (1 kg)
Annual Fuel Utilization Efficiency based on DOE test procedures and according to FTC labeling regulations. Isolated combustion system rating for non-weatherized furnaces.
NOTE − Filters and provisions for mounting are not furnished and must be field provided.
 The same C33 uncased models match the furnaces shown but require an optional adaptor base or field fabricated transition. See C33 coil bulletin for additional information.
 Cleanable polyurethane frame type filter.
 Flue connection on the unit is 4 in. (102 mm) diameter. Most applications will require 5 in. (127 mm) venting and field supplied 4 x 5 in. (102 x 127 mm) adaptor. See Venting
Tables in the Installation Instructions for detailed information.
 Not for use with RAB Return Air Base or with 60C and 60D size units with 2nd stage heating air flow requirements of 1800 cfm (850 L/s) or greater. See Blower Performance
Tables for additional information.