To Next Page

To Previous Page

Basic System Mode Configuration Example

ThisexampleshowstheparametersavailableforconfigurationinBasicSystem

mode:

Note: Youcaneitheracceptthedefaultvaluesorenternew parameters.

CN 4093# easyconnect

Configure Basic system (yes/no)? y

Please enter "none" for no hostname.

Enter hostname(Default: None)? host

Please enter "dhcp" for dhcp IP.

Select management IP address (Current: 10.241.13.32)?

Enter management netmask(Current: 255.255.255.128)?

Enter management gateway:(Current: 10.241.13.1)?

Pending switch port configuration:

Hostname: host

Management interface:

IP: 10.241.13.32

Netmask: 255.255.255.128

Gateway: 10.241.13.1

Confirm erasing current config to re-configure Easy Connect (yes/no)?