17
Installation of Expansion Cards
You can install your expansion card by following the steps outlined below:
1. Read the related expansion card's instruction document before installing the expansion card into the computer.
2. Remove your computer's chassis cover, screws and slot bracket from the computer.
3. Press the expansion card firmly into expansion slot in motherboard.
4. Be sure the metal contacts on the card are indeed seated in the slot.
5. Replace the screw to secure the slot bracket of the expansion card.
6. Replace your computer's chassis cover.
7. Power on the computer, if necessary, setup BIOS utility of expansion card from BIOS.
8. Install related driver from the operating system.
Installing a AGP expansion card:
AGP Card
2.Close the plastic clip at both edges of
the DIMM sockets to l ock the DIMM
module. Reverse the installation steps
when you wish to remove the DIMM
module.
Please carefully pull out the small
white-draw able bar at the end of the
AGP slot when you try to
install/uninstall the VGA card. Please
align the VGAcard to the onboard AGP
slot and press firmly down on the slot.
Make sure your VGA card is locked by
the small white-draw able bar.
To Next Page
Loading...
