This option is available only when Linear Frequency Control is enabled.
Please set DRAM Clock according to your requirement.
If you use DDR266 DRAM module, please set "DRAM Clock(MHz)" to 266. If you use
DDR333 DRAM module, please set "DRAM Clock(MHz)" to 333.
Incorrect using it may cause your system corrupted. For power users only!
AGP/PCI Clock Control
AUTO : Set AGP/PCI clock automatically. (Default)
EnAGP Clock (MHz)
This option is available only when AGP/PCI Clock Control is set to Manual.
Please set AGP Clock according to your requirement.
Incorrect using it may cause your system corrupted. For power users only!
PCI Clock (MHz)
When you select to set the AGP Clock (MHz) manually, the PCI Clock (MHz) will change
automatically depending on the AGP Clock (MHz) you set.
6-8 Top Performance
If you wish to maximize the performance of your system, enable "Top Performance."
1.Disabled: Disable this function. (Default Value)
2.Enabled: Enab
le Top Performance function.
"Top Performance" will increase H/Wworking speed. Different system configuration (both
H/W component and OS) will affect the result. For example, the same H/W configuration
might not run properly with Windows XP, but works smoothly with Windows NT. Therefore,
if your system is not perform enough, the reliability or stability problem will appear
sometimes, and we will recommend you disabling the option to avoid the problem as
mentioned above.
53
To Next Page
Loading...
