62
w!Italian
w!Korean
w!Spanish
DANGER
Electrical current from power, telephone and communication cables is hazardous.
To avoid a shock hazard:
w!Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration
of this product during an electrical storm.
w!Connect all power cords to a properlywired and grounded electrical outlet.
w!Connect to properlywired outlets any equipment that will be attached to this product.
w!When possible, use one hand only to connect or disconnect signal cables.
w!Never turn on any equipment when there is evidence offire, water, or structural damage.
w!Disconnect the attached power cords, telecommunications syste
ms, networks, and
modems before
you open the device covers, unless instructed otherwise in the installation and configuration
procedures.
w!Connect and disconnect cables as described in the following table when , moving, or opening
covers on this product or attached devices.
To Connect To Disconnect
1. Turn everything OFF. 1. Turn everything OFF.
2. First, attach all cables to devices. 2. First, remove power cords from outlet.
3. Attach signal cables to connectors. 3. Remove signal cables from connectors.
4. Attach power cords to outlet. 4. Remove all cables from devices.
5. A ttach power cords to outlet.
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent type
battery recommended by the manufacturer. Ifyour system has a module containing a lithium
battery, replace it onlywith the same module type made by the same manufacturer. The battery
contains lithium and can explode if not properly used, handled, or disposed of.
Do not:
w!Throw or immerse into water
w!Heat to more than 100°C (212°F)
w!Repair or disassemble
Dispose of the battery
as required by local ordinances or regulations.
To Next Page
Loading...
