1. Get the C:\PREBOOT\STARTUP\OPERA_010.CMD for editing by using the
RRUTIL process as described in “Using RRUTIL.EXE” on page 30.
2. Open the file for editing.
3. Locate the following line in the .CMD file: PYTHON.EXE.FAVS.PYC
Z:\OPERADEF6.ADR
4. Complete one of the following:
a. Type REM at the beginning of the line, as follows:
REM python.exe favs.pyc z:\Operadef6.adr
b. Delete the line of code from the file.
5. Save the file.
6. Put the file back by using the RRUTIL process described in “Using
RRUTIL.EXE” on page 30.
Changing proxy settings
To change the proxy settings for the Opera browser, do the following:
1. Get the file C:\PREBOOT\OPERA\PROFILE\norm1.ini by using the RRUTIL
process described in “Using RRUTIL.EXE” on page 30.
2. Open the file for editing.
3. Add the following section to the bottom of the norm1.ini file:
Note: The [0 or 1] variable indicates that the check item is either enabled (1) or
disabled (0).
[Proxy]
Use HTTPS=[0 or 1]
Use FTP=[0 or 1]
Use GOPHER=[0 or 1]
Use WAIS=[0 or 1]
HTTP Server=[HTTP server]
HTTPS Server=[HTTPS server]
FTP Server=[FTP server]
Gopher Server= [Gopher server]
WAIS Server Enable HTTP 1.1 for proxy=[0 or 1]
Use HTTP=[0 or 1]
Use Automatic Proxy Configuration= [0 or 1]
Automatic Proxy Configuration URL= [URL]
No Proxy Servers Check= [0 or 1]
No Proxy Servers =<IP addresses>
4. Save the file.
5. Put the file back by using the RRUTIL process described in “Using
RRUTIL.EXE” on page 30.
To add an HTTP, HTTPS, FTP, Gopher, or WAIS proxy server, type =<address of
proxy> after the appropriate line. For example, if the address of your proxy server
is http://www.your company.com/proxy, the HTTP Server line would read as
follows:
HTTP Server=http://www.your company.com/proxy
To add the port to the entry, place a colon after the address and type the port
number. The same is true for the ″No Proxy Servers″ and ″Automatic Proxy
Configuration URL″ fields.
z:\preboot\opera\profile\opera6.ini
Chapter 3. Configurations 43
To Next Page
Loading...
Need help?
General