Figure 71. Removing the M.2 solid-state drive
Figure 72. Installing the M.2 solid-state drive
9. Reinstall the removed parts.
10. Place the computer in an upright position.
11. If a locking device is available, use it to lock the computer.
12. Reconnect the external cables and power cords to the corresponding connectors on the computer.
Microprocessor
Prerequisite
Before you start, read Chapter 1 “Important safety information” on page 1 and print the following
instructions.
94
M70a and M90a Hardware Maintenance Manual
To Next Page
Loading...
