8. Install the 2.5-inch primary storage drive cage to the 3.5-inch primary storage drive cage.
9. Connect the signal cable and the power cable to the storage drive.
10. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
3.5-inch primary storage drive and bracket
1. Remove the computer cover. See “Computer cover” on page 42.
2. Disconnect the signal cable and the power cable from the 3.5-inch primary storage drive.
3. Pull the handle of the storage drive bracket to remove the storage drive with the bracket from the 3.5-
inch primary storage drive cage.
50 M90t User Guide
To Next Page
Loading...
