4. Remove the M.2 solid-state drive bracket.
5. Install the M.2 solid-state drive bracket.
6. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
Optical drive cage
Prerequisite
Before you start, read Appendix A “Important safety information” on page 85 and print the following
instructions.
Replacement procedure
1. Remove the computer cover. See “Computer cover” on page 42.
2. Remove the optical drive. See “Optical drive” on page 43.
3. Remove the front bezel. See “Front bezel” on page 46.
Chapter 7. CRU replacement 63
To Next Page
Loading...
