Figure 60. Installing the outer storage drive bracket
7. Connect the signal cable and the power cable to the new 2.5-inch storage drive.
8. Reinstall the removed parts. To complete the replacement, see “Completing the parts replacement” on
page 68.
Replacing the memory module
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
Ensure that you follow the order of installing memory modules shown in the following figure.
Figure 61. The order of installing memory modules
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
Chapter 4. Replacing hardware 43
To Next Page
Loading...
