Figure 106. Pivoting the socket downward
Figure 107. Securing the holder
7. Reconnect all cables that were disconnected from the system board.
8. Reinstall the removed parts. To complete the replacement, see “Completing the parts replacement” on
page 68.
Replacing the E-lock
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
Note: To remove the screws, you need a special tool (T15 star wrench).
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 17.
3. Disconnect the E-lock cable from the system board.
4. Replace the E-lock.
Chapter 4. Replacing hardware 63
To Next Page
Loading...
