Figure 110. Removing the cover presence switch
Figure 111. Installing the cover presence switch
7. Connect the new cover presence switch cable to the system board.
8. Reinstall the removed parts. To complete the replacement, see “Completing the parts replacement” on
page 68.
Replacing the rear fan
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 17.
3. Remove the front bezel. See “Replacing the front bezel” on page 18.
Chapter 4. Replacing hardware 65
To Next Page
Loading...
