3.
Using the feature pack submodel ID, locate the corresponding Controller submodel ID for the
starting configuration and find the Feature Activation Code for the desired ending configuration
within the table below. Then, copy that Feature Activation Code to a text file.
Baseboard ports are disabled when running an NVMe protocol on the HIC.
◦ For the controller that has two base-board ports on the rear:
DE6000H
Starting configuration Ending configuration Feature
Code
Controller
submodel
ID
Baseboard
ports
HIC ports Controller
submodel
ID
Baseboard
ports
HIC ports
432 FC per HIC 433 iSCSI per HIC B4JM
433 iSCSI per HIC 432 FC per HIC B4XD
441 Disabled NVMe-oF 433 iSCSI per HIC B6Z0
433 iSCSI per HIC 441 Disabled NVMe-oF B6Z1
441 Disabled NVMe-oF 432 FC per HIC B6Z2
432 FC per HIC 441 Disabled NVMe-oF B6Z3
DE6000F
133
To Next Page
Loading...
