b.
Select the failed drive on the shelf graphic.
c.
Click the drive to display its context menu, and then select View settings.
d.
Confirm that the replacement drive has a capacity equal to or greater than the drive you are
replacing and that it has the features you expect.
For example, do not attempt to replace a hard disk drive (HDD) with a solid-state disk
(SSD). Similarly, if you are replacing a secure-capable drive, make sure the replacement
drive is also secure-capable.
3.
If needed, use ThinkSystem System Manager to locate the drive within the storage array.
a.
If the shelf has a bezel, remove it so you can see the LEDs.
b.
From the drive’s context menu, select Turn on locator light.
The drive drawer’s Attention LED (amber) blinks so you can open the correct drive drawer to
identify which drive to replace.
(1) Attention LED
c.
Pull out the drive tray drawer by unlatching the two orange levers on each side of the
drawer. After the orange latches are released, grab the handle in location shown and pull
out drawer.
61
To Next Page
Loading...
