Lenovo ThinkSystem SD530 V3 - Page 22

Notes:
• To avoid throttling, make sure to adopt passive Direct Attach cables when network adapters with 100GbE or higher
speed are installed.
• Two-processor configuration is supported up to 30°C.
• If PCIe adapter with up to 2 ports is installed, the configuration only supports OCP module with up to 4 ports.
• If PCIe adapter with up to 4 ports is installed, the configuration only supports OCP module with up to 2 ports.
When E3.S PM1743 15.36TB drive is installed, the ambient temperature must be limited to 30°C or lower.
• Keep the ambient temperature to 35°C or lower with the following system configuration:
Table 3. Configurations with one processor, under 35°C
Processor configuration
Conditionally supported
components
Commonly supported
components
– One processor with up to 350-
watt TDP
– Performance heat sink
– One PCIe Ethernet adapter
– No OCP module
– Up to eight 96 GB RDIMMs
– Up to two E3.S 1T drives
– Up to two M.2 drives
– No PCIe adapter
– One OCP module
– One processor with up to 300-
watt TDP
– Performance heat sink
– One PCIe adapter with 2 ports
– One OCP module
– Up to eight 96 GB RDIMMs
– Up to two E3.S 1T drives
– Up to two M.2 drives
– One PCIe Ethernet adapter
– One OCP module with 2 ports
– One GPU adapter
– One OCP module
– One processor with up to 185-
watt TDP
– Standard heat sink
– Up to eight 128 GB 3DS
RDIMMs
– One PCIe adapter with 2 ports
– One OCP module
– Up to two E3.S 1T drives
– Up to two M.2 drives
– Up to eight 128 GB 3DS
RDIMMs
– One PCIe Ethernet adapter
– One OCP module with 2 ports
– Up to eight 96 GB RDIMMs
– One GPU adapter
12 ThinkSystem SD530 V3 System Configuration Guide