Figure 58. Adjustment of an M.2 drive retainer
After this task is completed
1. Install the required M.2 drive (see
“Install an M.2 drive” on page 103).
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install an M.2 drive
Follow instructions in this section to install an M.2 drive.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read
“Installation Guidelines” on page 41 and “Safety inspection checklist” on page 42 to make sure that
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1. Locate the M.2 connectors on the system board. Then, determine to which connector the M.2 drive
is to be installed.
Chapter 5. Hardware replacement procedures 103
To Next Page
Loading...
