Lenovo ThinkSystem SD530 V3 - Page 116

• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
“Remove the top cover” on page 168).
Step 2. Locate the memory module slots and determine which memory module is to be removed from the
node.
Figure 61. Memory modules and processors layout
Step 3. Remove the memory module from the slot.
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, handle the
retaining clips gently.
a.
Open the retaining clip at each end of the memory module slot.
b. Carefully hold both ends of the memory module and lift it out of the slot.
106
ThinkSystem SD530 V3 User Guide