1 Heat sink
9 Clips to secure processor in carrier
2 Heat sink triangular mark 10 Processor ejector handle
3 Processor identification label
11 Carrier triangular mark
4 Nut and wire bail retainer 12 Processor heat spreader
5 Torx T30 nut 13 Thermal grease
6 Anti-tilt wire bail 14 Processor contacts
7 Processor carrier 15 Processor triangular mark
8 Clips to secure carrier to heat sink
Procedure
Step 1. Make preparations for this task.
a. Power off the node (see “Power off the node” on page 51); then, disconnect all external cables
from the node.
b. Remove the node from the chassis (see
“Remove a node from the chassis” on page 72); then,
carefully lay the node on a flat, static-protective surface, orienting the node with the front
toward you.
Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
“Remove the top cover” on page 168).
d. For one-processor configuration, remove the 1U standard heat sink or 1U performance heat
sink that is installed on the front of the node.
Figure 85. PHM location for one-processor configuration
e. For two-processor configuration, remove the 1U standard heat sink that is installed on the
front of the node, or the 1U performance heat sink that is installed on the rear of the node.
132
ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
