Figure 125. Installation of the top cover
After this task is completed
1. Reinstall the node into the chassis (see
“Install a node to the chassis” on page 75).
2. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
“Install a hot-swap power supply” on page 61 and “Power on the node” on page
51
.)
3. Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 171).
Complete the parts replacement
Go through the checklist to complete parts replacement.
To complete the parts replacement, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws are
left inside the node.
2. Properly route and secure the cables in the node. Refer to the cable connecting and routing information
for each component (see
Chapter 6 “Internal cable routing” on page 173).
3. Reinstall the node into the chassis (see
“Install a node to the chassis” on page 75).
4. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
“Install a hot-swap power supply” on page 61 and “Power on the node” on page
51
.)
5. Update the system configuration.
• Download and install the latest device drivers:
http://datacentersupport.lenovo.com.
Chapter 5. Hardware replacement procedures 171
To Next Page
Loading...
