Figure 135. Cables for the rear I/O module and OCP module
From
To (system board)
Cable
1 Node bottom (secured with
screws)
1a OCP power and sideband
connector
OCP connector to MCIO x8 (270 mm)
1b OCP signal connector
OCP connector to MCIO x16 (450
mm)
From
To (system board)
Cable
1 Rear I/O signal connector (on the
rear I/O module)
1 Rear I/O signal connector
Low-profile SlimSAS x8 to low-profile
SlimSAS x8 (915 mm)
Note: When connecting the rear I/O cable to the rear I/O module, make sure to secure the attached
grounding cable with a screw.
180
ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
