CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended
for use as a shelf.
Attention:
• Read
“Installation Guidelines” on page 41 and “Safety inspection checklist” on page 42 to make sure that
you work safely.
• To install the rails into a rack, follow the instructions below:
https://pubs.lenovo.com/st650-v2/thinksystem_l_shaped_rail_kit.pdf
After the rails are installed successfully, complete the following steps to install the chassis to the rack.
CAUTION:
Use safe practices when lifting the chassis.
Procedure
Step 1. Make preparations for this task.
a. If the EIA brackets are not installed to the front of the chassis yet, install them (see
“Install the
EIA brackets to the chassis” on page 57
).
Step 2. Align the chassis with the rails; then, slide the chassis into the rack.
Step 3. Tighten the captive screws on the front to secure the chassis to the rack.
Figure 18. Chassis installation
Chapter 5. Hardware replacement procedures 55
To Next Page
Loading...
