• Read “Installation Guidelines” on page 41 and “Safety inspection checklist” on page 42 to make sure that
you work safely.
Procedure
Step 1. Make preparations for this task.
a. Power off all the nodes (see
“Power off the node” on page 51); then, disconnect all external
cables from the nodes.
b. Remove all the nodes from the chassis (see
“Remove a node from the chassis” on page 72).
c. Remove all power supply units and PSU fillers from the PSU cage (see
“Remove a hot-swap
power supply” on page 58
and Removal of a PSU filler).
d. Remove the chassis from the rack (see
“Remove the chassis from the rack” on page 52); then,
lay the chassis on a flat, static-protective surface.
Step 2. Remove the left and right EIA brackets from the chassis.
a. Remove the screws that secure the EIA brackets to the chassis.
b. Remove the EIA brackets from the chassis.
Figure 20. Removal of the EIA brackets
After this task is completed
1. Install a replacement unit (see “Install the EIA brackets to the chassis” on page 57).
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the EIA brackets to the chassis
Follow instructions in this section to install the EIA brackets to the chassis.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read
“Installation Guidelines” on page 41 and “Safety inspection checklist” on page 42 to make sure that
you work safely.
Chapter 5. Hardware replacement procedures 57
To Next Page
Loading...
