Note: The color of the CRPS power supply unit release tab might be different from the
illustration.
Figure 22. Removal of a hot-swap PSU
After this task is completed
1. Install a replacement unit or filler (see “Install a hot-swap power supply” on page 61) .
Important:
• A removed hot-swap power supply must be replaced by another power supply unit or a PSU filler
within two minutes after removal.
• For PSU slots 2 and 3, the PSU filler must be installed with the latch downward. For PSU slot 1, the
filler must be installed with the latch upward.
60
ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
