Procedure
Step 1. Make preparations for this task.
a. Power off the node (see
“Power off the node” on page 51); then, disconnect all external cables
from the node.
b. Remove the node from the chassis (see
“Remove a node from the chassis” on page 72); then,
carefully lay the node on a flat, static-protective surface, orienting the node with the front
toward you.
Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
“Remove the top cover” on page 168).
Step 2. Disconnect all the cables from the drive backplane.
Step 3. Remove the drive cage assembly from the node.
a.
Remove the seven screws that secure the cage.
b.
Lift the cage out of the node.
Figure 42. Removal of the drive cage assembly
Step 4. Lay the drive cage on a flat, static-protective surface.
After this task is completed
1. Install a replacement unit (see
“Install a drive cage assembly” on page 88).
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
