Step 4. Use the screwdriver in the Misc kit to hook the cable as shown, and remove the cable from the M.2
WLAN module. Apply the same method to the main cable and the AUX cable.
Note: Carefully to remove the cables, make sure the cable is removed vertically without excessive
force.
Figure 88. M.2 WLAN module removal
Step 5. Use screwdriver in the Misc kit to counterclockwise remove the nut and the washer on the rear of
the server.
Note: Apply the same method to remove both main and AUX cable.
Figure 89. M.2 WLAN module removal
Table 29. M.2 WLAN module removal
1 M.2 WLAN module cable 3 Nut
2 Washer
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Chapter 3. Hardware replacement procedures 93
To Next Page
Loading...
