Figure 101. Node removal
Notes:
• The node removed from the enclosure is without top cover. If the node is not to be reinstalled to
an enclosure, make sure to install the top cover. See
“Install the top cover” on page 141.
• If the node is removed from an E1 Enclosure (1U 2-node) and is not to be reinstalled to the E1
Enclosure, change the vital product data (VPD) to the default mode for proper operation.See
“Change the VPD for E1 Enclosure configuration (trained technician only)” on page 139.
Step 2. To remove the node from the node sleeve, complete the following steps.
a. Loosen the two thumbscrews and slide the node of the node sleeve.
Figure 102. Node removal
100 ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
