Lenovo ThinkSystem SE350 - Power Adapter Replacement; Remove a Power Adapter

Figure 115. 12 V power distribution module installation
• -48 V power distribution module installation
Figure 116. -48 V power distribution module installation
After you install the power distribution module, complete the following steps:
1. Install the node if needed (see
“Install a node” on page 101).
2. Reconnect power cords and all external cables.
3. If necessary, configure the RAID array using the Setup utility configuration.
Power adapter replacement
Use this information to remove and install a power adapter.
Remove a power adapter
Use this information to remove a power adapter.
Before you remove a power adapter, complete the following steps:
1. Read the following sections to ensure that you work safely.
• “Safety” on page iii
• “Installation Guidelines” on page 37
110
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual