2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Remove the enclosure from the rack if necessary.
To remove a power adapter, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Step 1. Remove the power adapter.
• If you are removing a power adapter while a node is installed in an enclosure, complete the
following steps.
1. Remove the two screws.
2. Slightly push the bracket frontward and remove it from the enclosure.
– E1 Enclosure (1U 2-node)
Figure 117. Bracket removal
– E2 Enclosure (2U 2-node)
Chapter 3. Hardware replacement procedures 111
To Next Page
Loading...
