Figure 127. Power adapter installation
1. Install the enclosure into rack if necessary.
2. Refer to Configuration Installation Guide for the DIN rail configuration and wall-mounted configuration
installation details if necessary.
3. Reconnect power cords and all external cables.
4. Turn on the server (see
“Power on the server” on page 16).
Rubber feet replacement
Use this procedure to remove or install the rubber feet.
Remove the rubber feet
Use this information to remove the rubber feet.
Before you remove the rubber feet, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Remove the node from the enclosure if needed (see
“Remove a node” on page 98).
To remove the rubber feet, complete the following steps:
Chapter 3. Hardware replacement procedures 119
To Next Page
Loading...
