2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
3. If an insulating pull tab is under the CMOS battery on the replacement system board, remove it.
Figure 140. Insulating pull tab removal
To install the system board, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Step 1. Insert the system board into the chassis with an angle as shown.
Figure 141. System board installation
Step 2. Push the system board into the server and seat the system board onto the guide pins.
Chapter 3. Hardware replacement procedures 129
To Next Page
Loading...
