To change the VPD to the default mode, complete the following steps:
1. Enable IPMI on Lenovo XClarity Controller web interface or Lenovo XClarity Essentials OneCLI.
2. Implement the following IPMI commands:
ipmitool raw 0x3A 0x0C 0x0E 0x01 0x10 0x54 0x68 0x69 0x6e 0x6b 0x53 0x79 0x73 0x74 0x65 0x6d 0x20
0x53 0x45 0x33 0x35 0x30 0x20 0x20 0x20 0x20 0x20 0x20 0x20 0x20 0x20 0x20 0x20 0x20
3. For data security purpose, make sure to disable IPMI again on Lenovo XClarity Controller web interface
or Lenovo XClarity Essentials OneCLI.
Top cover replacement
Use the following information to remove and install the top cover.
Remove the top cover
Use this information to remove the top cover.
To avoid possible danger, read and follow the following safety information.
S012
CAUTION:
Hot surface nearby.
S014
CAUTION:
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is
authorized to remove the covers where the label is attached.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Before you remove the top cover, complete the following steps:
1. Read the following sections to ensure that you work safely.
140
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
