• “Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Remove the node from the enclosure if needed (see
“Remove a node” on page 98).
4. Remove the intrusion switch (see
“Remove the intrusion switch cable” on page 72).
To remove the M.2 boot adapter, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Step 1. Grasp the M.2 boot adapter at both ends and pull it straight up to remove it from the system board.
Figure 23. M.2 boot adapter removal
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install the M.2 boot adapter
Use this information to install the M.2 boot adapter.
Before you install the M.2 boot adapter, complete the following steps:
1. Read the following sections to ensure that you work safely.
• “Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
To install the M.2 boot adapter, complete the following steps:
40
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
