Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
For more information about the M.2 adapter, see
https://lenovopress.com/lp0769-thinksystem-m2-drives-
adapters
.
Step 1. Align the M.2 boot adapter with the connector on the system board, and press the adapter straight
into the connector.
Figure 24. M.2 boot adapter installation
After you install the M.2 boot adapter, complete the following steps:
1. Install the intrusion switch (see
“Install the intrusion switch cable” on page 73).
2. Install the node if needed (see
“Install a node” on page 101).
3. Reconnect power cords and all external cables.
Remove the M.2 WLAN/LTE wireless adapter
Use this information to remove the M.2 WLAN/LTE wireless adapter.
Before you remove the M.2 WLAN/LTE wireless adapter, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Remove the node from the enclosure if needed (see
“Remove a node” on page 98).
4. Remove the lock position switch if installed (see
“Remove the lock position switch” on page 75).
To remove the M.2 WLAN/LTE wireless adapter, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Chapter 3. Hardware replacement procedures 41
To Next Page
Loading...
