• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Remove the node from the enclosure if needed (see
“Remove a node” on page 98).
4. Remove the PCIe riser assembly (see
“Remove the PCIe riser assembly” on page 103 for instructions).
To remove a M.2 data adapter, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Step 1. Remove the screws on the both side to remove the bezels from the riser assembly.
Figure 27. M.2 data adapter removal
Step 2. Remove the screws.
Step 3. Grasp the M.2 data adapter by its edges and carefully pull it out of the slot.
• M.2 riser assembly
44
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
