Lenovo ThinkSystem SE350 - CMOS Battery (CR2032) Replacement; Remove the CMOS Battery (CR2032)

2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
To install the air baffle, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Figure 36. Air baffle installation
Step 1. Align the tabs on both sides of the air baffle with the corresponding slots; then, lower the air baffle
into the chassis and press the air baffle down until it is securely seated.
After you install the air baffle, complete the following steps:
1. Install the node if needed (see
“Install a node” on page 101).
2. Reconnect power cords and all external cables.
CMOS battery (CR2032) replacement
Use the following information to remove and install the CMOS battery.
Remove the CMOS battery (CR2032)
Use this information to remove the CMOS battery.
To avoid possible danger, read and follow the following safety information.
S002
52
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual