Figure 45. Dust filter removal
Step 2. Remove the dust filter out of the locking bezel.
Figure 46. Dust filter removal
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install the dust filter in locking bezel
Use this information to install the dust filter in locking bezel.
Before you install the dust filter in locking bezel, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
Chapter 3. Hardware replacement procedures 61
To Next Page
Loading...
