Lenovo ThinkSystem SE350 - Remove the Dust Filter in E1 Enclosure; Bracket

3. Depends on the environment of the server, check the status of the dust filter every 3 months to make
sure it is functional.
To install the dust filter in locking bezel, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Step 1. Align the dust filter with the slot in locking bezel, and place the filter into the slot.
Figure 47. Dust filter installation
Step 2. Rotate the dust filter holder into the slot until it clicks.
Figure 48. Dust filter installation
After you install the dust filter in locking bezel, complete the following steps:
1. Install the node if needed (see
“Install a node” on page 101).
2. Reconnect power cords and all external cables.
Remove the dust filter in E1 enclosure bracket
Use this information to remove the dust filter in E1 enclosure bracket.
Before you remove the dust filter in E1 enclosure bracket, complete the following steps:
1. Read the following sections to ensure that you work safely.
62
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual