To avoid personal injury, disconnect the fan cables before removing the fan from the device.
Before you remove the lock position switch, complete the following steps:Before you install the lock position
switch, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Remove the node from the enclosure if needed (see
“Remove a node” on page 98).
4. Remove the PCIe riser cage (see
“Remove the PCIe riser assembly” on page 103).
To remove the lock position switch, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Step 1. Disconnect the cable.
Figure 62. Lock position switch cable
Step 2. Remove the screw.
Step 3. Slightly push the lock position switch rightward and remove it from the server.
76
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
