4. Remove a M.2 data adapter (see “Remove a M.2 data adapter” on page 43).
To remove an M.2 drive from an M.2 data adapter, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Figure 68. M.2 drive removal
Note: In the removal process, carefully proceed the steps to prevent the drives from dropping.
Step 1. Remove the screw on the top of the adapter.
Step 2. Rotate the M.2 drive on the top upward.
Step 3. Pull out the M.2 drive on the top from the M.2 data adapter.
Step 4. Remove the screw on the bottom of the adapter.
Step 5. Rotate the M.2 drive on the bottom downward.
Step 6. Pull out the M.2 drive on the bottom from the M.2 data adapter.
Step 7. (Optional) Remove the retainer by pulling it backward and lifting it up.
After you remove an M.2 drive, complete the following steps:
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install an M.2 drive on an M.2 data adapter
Use this information to install M.2 drive on an M.2 data adapter.
Before you install an M.2 drive, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
Chapter 3. Hardware replacement procedures 81
To Next Page
Loading...
