Figure 76. M.2 LTE module installation
Step 2. Connect the cables to the connectors on the M.2 LTE module as shown. Press the cable down until
it clicks.
Notes:
• Make sure the cables are connected to the right connector. Black cable connected to “Main”
connector, gray cable connected to “Aux” connector.
• Carefully perform the step without excessive force to prevent the connector from damage.
• Make sure the cables are connected to the connectors properly, you should be able to rotate the
cable horizontally without it detached easily.
Figure 77. M.2 LTE module installation
Step 3. Slide the cable holder onto the M.2 LTE module.
Figure 78. M.2 LTE module installation
Chapter 3. Hardware replacement procedures 87
To Next Page
Loading...
