Figure 24. Processor locations on system board
Complete the following steps to install a PHM.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DtV8A4UWy7d3AoFKjCvas3
.
Step 1. Remove the processor socket cover, if one is installed on the processor socket, by placing your
fingers in the half-circles at each end of the cover and lifting it from the system board.
Step 2. Install the processor-heat-sink module on the system board.
48
ThinkSystem SN850 Compute Node Setup Guide
To Next Page
Loading...
