Step 4. Connect the cable of the serial port module to serial-port-module connector on the system board.
To locate the connector, see “System board components” on page 27. If the serial port module is
installed in PCIe slot 1, route the cable of the serial port module as shown.
Figure 89. Cable routing for serial port module installed in PCIe slot 1
After installing the serial port module:
1. Complete the parts replacement. See “Complete the parts replacement” on page 144.
2. To enable the serial port module, do one of the following according to the installed operating system:
• For Linux operating system:
Open the ipmitool and enter the following command to disable the Serial over LAN (SOL) feature:
-I lanplus -H IP -U USERID -P PASSW0RD sol deactivate
• For Microsoft Windows operating system:
a. Open the ipmitool and enter the following command to disable the SOL feature:
-I lanplus -H IP -U USERID -P PASSW0RD sol deactivate
b. Open Windows PowerShell and enter the following command to disable the Emergency
Management Services (EMS) feature:
Bcdedit /ems no
c. Restart the server to ensure that the EMS setting takes effect.
Chapter 3. Hardware replacement procedures 123
To Next Page
Loading...
