Rack latches replacement
Use this information to remove and install the rack latches.
Remove the rack latches
Use this information to remove the rack latches.
“Read the
installation
Guidelines” on
page 45
Before removing the rack latches:
1. If you have installed the security bezel, remove it. See “Remove the security bezel” on page 53.
2. Use a flat-blade screwdriver to remove the ID label plate on the right rack latch and place it in a safe
place.
Figure 21. ID label plate removal
To remove the rack latches, complete the following steps:
Watch the procedure. A video of the removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-AQrHuDWK6L3KtHWc6maY_O
• Youku: http://list.youku.com/albumlist/show/id_50437162
Chapter 3. Hardware replacement procedures 49
To Next Page
Loading...
