Figure 149. System board assembly installation
a. Hold the lift handle 1 and the release pin 2 at the same time to lower the system board into
the chassis.
b.
Slide the system board to the rear of the server until the system board snaps into position.
Ensure that:
• The rear connectors on the new system board are inserted into the corresponding holes in
the rear panel.
• The release pin
2 secures the system board in place.
After you finish
1. Install any components that you have removed:
•
“Install a processor” on page 153
• “Install a memory module” on page 126
• “Install the CMOS battery” on page 73
• “Install the RAID flash power module on the chassis” on page 161
• “Install a system fan” on page 210
206
ThinkSystem SR635 V3 User Guide
To Next Page
Loading...
