Cable routing for onboard configuration
The following figure illustrates the cable routing for the onboard configuration of 4 x 2.5-inch front SAS/SATA
drive bays.Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n .
Figure 187. Cable routing for onboard configuration of 4 x 2.5-inch front SAS/SATA drive bays
Table 28. Mapping between backplane connectors and system board assembly connectors for onboard configuration
From To
1 SAS on the front backplane 1 PCIe connector 8 on the system board assembly
Chapter 6. Internal cable routing 249
To Next Page
Loading...
