Lenovo ThinkSystem SR635 - Page 206

Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DTDY1lmpIPpJVOzo7dKq14
• Youku: http://list.youku.com/albumlist/show/id_52222446.html
Note: Depending on the model, the blue lift handle on your system board might look slightly different from
the illustration below.
Figure 179. System board installation
Step 1. Hold the release pin 1 and the lift handle 2 at the same time to lower the system board into the
chassis.
Step 2. Slide the system board to the rear of the server until the system board snaps into position. Ensure
that:
• The new system board is engaged by the mounting stud
3 on the chassis.
• The rear connectors on the new system board are inserted into the corresponding holes in the
rear panel.
• The release pin
1 secures the system board in place.
After installing the system board:
1. Push the power supplies into the bays until they click into place.
2. Install any of the following components that are removed from the system board. See the related topics
in this chapter. See Chapter 3 “Hardware replacement procedures” on page 79
• Fan board
• PIB board
• System fans
196
ThinkSystem SR635 Maintenance Manual