Six 2.5-inch SATA drives, four 2.5-inch NVMe drives and rear NVMe drive assembly
Notes:
• When the SAS/SATA backplanes are connected to PCIe connectors on the system board, only SATA
drives are supported. No SAS drives are supported.
• The cable routing illustration is based on the scenario that the rear hot-swap drive cage is installed.
Depending on the model, the rear hot-swap drive cage might not be available on your server.
Figure 43. Cable routing for server model with six 2.5-inch SATA drives, four 2.5-inch NVMe drives and rear NVMe drive
assembly
Cable
From To
1 NVMe signal cable for front
backplane
NVMe 0 and NVMe 1 connectors on
the front backplane
PCIe connector 1 on the system
board
2 NVMe signal cable for front
backplane
NVMe 2 and NVMe 3 connectors on
the front backplane
PCIe connector 2 on the system
board
3 SAS signal cable for front
backplane
SAS 0 and SAS1 connectors on the
front backplane
PCIe connector 6 on the system
board
4 SAS signal cable for front
backplane
SAS 2 connector on the front
backplane
PCIe connector 7 on the system
board
5 NVMe signal cable for rear
backplane
NVMe connectors on the rear
backplane
PCIe connector 3 on the system
board
52 ThinkSystem SR635 Maintenance Manual
To Next Page
Loading...
