Step 3. If necessary, reinstall the PCIe adapters on the riser card. See Install a PCIe adapter. Then, refer to
your note to reconnect any cables of the PCIe adapters on the riser card. Or you can refer to the
Internal cable routing and locate the cable routing information for your configuration options.
Step 4. Position the riser assembly on the chassis. Align the plastic clip and two pins on the bracket with
the guide pin and two holes on the chassis and align the riser card with the riser slot on the system
board. Then, carefully press the riser assembly straight down into the slot until it is fully seated.
Figure 116. Riser assembly installation
After you finish
Complete the parts replacement. See Complete the parts replacement.
222
ThinkSystem SR645 Maintenance Manual
To Next Page
Loading...
