Server model with two 2.5-inch hot-swap rear drive bays and one PCIe slot
The following illustration shows the rear view of the server model with two hot-swap drive bays and one PCIe
slot. Depending on the model, your server might look slightly different from the illustration below.
Table 14. Components on the rear of the server
1 PCIe slot 1 on riser 1 assembly 2 Rear 2.5-inch drive bays (2)
4 Power supply 2 (optional)
5 Power supply 1
6 NMI button
7 USB 3.1 Gen 1 connectors (3)
8 VGA connector 9 XClarity Controller network connector
10 Ethernet connectors on OCP 3.0 Ethernet adapter
(optional, two or four connectors may be available)
Note: For more information about each component, see Rear components overview.
Chapter 2. Server components 37
To Next Page
Loading...
