Configuration 3 and 4: (front drive bays and rear drive bays)
Front: one 4 x 3.5-inch SAS/SATA backplane
Rear: one 2 x 2.5-inch SAS/SATA backplane
Config.
Front BP Rear BP
System board
Storage controller
SFF 8i RAID/HBA
3
SAS PCIe 2
SAS PCIe 5
4 SAS SAS
Gen 4: C 0
Gen 3: C 0, C 1
The following illustration shows the cable routing for the configuration 4, the routing for configuration 3 is
similar. Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Note: For models that support Gen 3 and Gen4 adapters at the same slot, the illustration shows only the
cable routing information for Gen 4 adapters, the routing and connector information is similar for Gen 3
adapters.
Figure 19. Cable routing for configuration 4
Chapter 3. Internal cable routing 69
To Next Page
Loading...
